#### Quiz-summary

0 of 15 questions completed

Questions:

- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 11
- 12
- 13
- 14
- 15

#### Information

Click on Start Quiz button to take the Online test.Below materials will help you crack KPTCL Exams with Ease.

You have already completed the quiz before. Hence you can not start it again.

Quiz is loading...

You must sign in or sign up to start the quiz.

You have to finish following quiz, to start this quiz:

#### Results

0 of 15 questions answered correctly

Your time:

Time has elapsed

You have reached 0 of 0 points, (0)

Average score | |

Your score |

#### Categories

- Not categorized 0%

Pos. | Name | Entered on | Points | Result |
---|---|---|---|---|

Table is loading | ||||

No data available | ||||

- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 11
- 12
- 13
- 14
- 15

- Answered
- Review

- Question 1 of 15
##### 1. Question

The maximum value of f(x) = x3-9×2+24x+5 in the interval [1, 6] is (where number after x denote power like x3 is x cube)

CorrectIncorrect - Question 2 of 15
##### 2. Question

An 8-pole, 3-phase, 50 Hz induction motor is operating at a speed of 700 rpm. The frequency of the rotor current of the motor in Hz is

CorrectIncorrect - Question 3 of 15
##### 3. Question

The dc current flowing in a circuit is measured by two ammeters, one PMMC and another electrodynamometer type, connected in series. The PMMC meter contains 100 turns in the coil, the flux density in the air gap is 0.2 Wb/m2, and the area of the coil is 80 mm2. The electrodynamometer ammeter has a change in mutual inductance with respect to deflection of 0.5 mH/deg. The spring constants of both the meters are equal. The value of current, at which the deflections of the two meters are same, is (where m2 and mm2 are m sqaure and mm square)

CorrectIncorrect - Question 4 of 15
##### 4. Question

The output of a continuous-time, linear time-invariant system is denoted by T{x(t)} where x(t) is the input signal. A signal z(t) is called eigen-signal of the system T , when T{z(t)} = a y(t), where a is a complex number, in general, and is called an eigenvalue of T. Suppose the impulse response of the system T is real and even. Which of the following statements is TRUE?

CorrectIncorrect - Question 5 of 15
##### 5. Question

The self inductance of the primary winding of a single phase 50Hz transformer is 800mH and that of the secondary winding is 600mH.The mutual inductance between these two winding is 480mH.The secondary winding of this transformer is short circuited and the primary winding is connected to a 50Hz single phase sinusoidal voltage source.The current flowing in both the windings is less than their respective rated current.The resistance of both windings can be neglected.What is the effective inductance (in mH) seen by the source?

CorrectIncorrect - Question 6 of 15
##### 6. Question

The angle between two adjacent asymptotes in a root locus diagram is

CorrectIncorrect - Question 7 of 15
##### 7. Question

For an R-L-C series circuit in resonance, the following statement is not correct

CorrectIncorrect - Question 8 of 15
##### 8. Question

The meter constant of a single-phase energy meter is 500 rev/kWh. It is found that with a load of 5 kW, it makes 40 revolutions in 50 sec. The percentage error is

CorrectIncorrect - Question 9 of 15
##### 9. Question

The impulse response of a linear system is e to the power -t, t > 0.The corresponding transfer function is

CorrectIncorrect - Question 10 of 15
##### 10. Question

(a)Both Statement(I) and Statement(II) are individually true and Statement(I1) is the correct explanation of Statement (I)

(b)Both Statement(I) and Statement(II) are individually true but Statement (II) is not the correct explanation of Statement (I)

(c)Statement(I) is true but Statement (II) is false

(d)Statement(I) is false but Statement (II) is trueStatement (1):

Under steady-state conditions, a pure inductance acts as a short circuit for direct current.

Statement (II):

The potential drop across an inductance is proportional to the rate of change of current.CorrectIncorrect - Question 11 of 15
##### 11. Question

A 4-pole do generator is running at 1500 rpm.The frequency of current in the armature winding is (a)50 Hz (b)150 Hz (c)25 Hz (d)100 Hz

CorrectIncorrect - Question 12 of 15
##### 12. Question

Power transmission lines are transposed to reduce

CorrectIncorrect - Question 13 of 15
##### 13. Question

Virtual ground property of operational amplifier indicates that

CorrectIncorrect - Question 14 of 15
##### 14. Question

For a memory system the cycle time is

CorrectIncorrect - Question 15 of 15
##### 15. Question

The following events will not happen when quantizing noise is decreased in PCM

CorrectIncorrect

## Leaderboard: WBSEDCL 1

Pos. | Name | Entered on | Points | Result |
---|---|---|---|---|

Table is loading | ||||

No data available | ||||